


In the not too distance past, procuring a low phase noise 1 GHz source was very expensive, limiting it to only very high-end applications that could support the cost of incorporating this technology in the design.
Employing a compact, low-phase noise, high-frequency source in your design will combine the best attributes...



This paper will give an overview of both high and low throw-count RF switches used in different circuit locations in a typical mobile device design, and discuss how each performance specification and design feature will impact on the overall performance of your system. In addition, this paper will dive deeper inside each...



Safety, availability, and cost considerations can make performing thorough tests of embedded control devices using the complete system impractical. Hardware-in-the-loop (HIL) simulation is a real-time test technique used to test these devices more efficiently. During HIL test, the physical system that interfaces...
Published: Apr 01, 2021



The more successful a gate driver is in reducing power-up and power-down times, the bigger the headache for accurate measurements. Both choosing the right probe and optimizing the probing technique are significant factors in improving measurement accuracy.
This whitepaper provides guidelines.



The electronics industry never sleeps. Technical evolution drives the beating heart of the global industry and permeates everything. One example is wireless communication. Wi-Fi, Bluetooth ® , and cellular communications may be familiar and trusted methods but their specifications and performance capabilities today...
Published: May 21, 2021



High-voltage power management ICs, such as TI’s LM5000 series of integrated controllers and regulators, can simplify the design of high-voltage power management solutions
This paper presents various application scenarios where high-voltage capability up to 100V is required and explains how high-voltage power...



Power system designers can now benefit from flexibility and the ability to customize electrical parameters by using configurable and programmable power supplies as well as fast and low-cost modifications of the electrical and mechanical properties of standard power supplies.
This white paper explains how, through...



This article describes best practices for new designs of PROFIBUS DP nodes, and covers bus node isolation, PROFIBUS compliance, and bus signal polarity. It includes a review of a new family of PROFIBUS International recognized isolated transceivers, whose isolation technology is based on Giant Magneto Resistance (GMR)....



To guarantee the correct behavior of real-time software running on embedded processors can pose a significant challenge. Data-dependent control flow, where execution times of many functions are dependent on the data inputs, means that instruction sequences are hard to predict.
This document explains how static timing...



In less than a decade, tens of billions of electronic devices will be connected to the Internet-of-Things (IoT), a vast infrastructure of smart products that represent tens of thousands of different applications. Each of us will typically interact with hundreds of devices every day in order to control and monitor systems...



An Analog to Digital Converter (ADC) is a common analog building block and almost always is needed when interfacing digital logic, like that in an FPGA or CPLD, to the “real world” of analog sensors.
This white paper will explain the implementation of both a low frequency (DC to 1K Hz) and higher...



Mutation testing checks the quality of your test cases. Automated mutation testing is the most important new functionality in the new main version V4.3 of TESSY, the tool for automated unit / module and integration testing of embedded software.
What is the purpose of such code mutations and how does mutation testing...
Published: Mar 02, 2021



This webinar explores the topic of debugging CAN bus interfaces by using an oscilloscope. We will be talking about topics such as sources of bus errors, EMI debug correlation with protocol decode, boot cycle testing, application specific triggering, eye measurements and more.
Attendees of the webinar will gain insightful...
Published: Aug 23, 2021



Rail voltages are getting smaller, and tolerances are decreasing. As a result, making accurate power rail measurements has become much more difficult.
Industry dynamics are driving both a decrease in rail voltage values as well as tighter tolerances across a wide range of rails. Making an accurate ripple measurement...